|pump calpeda NGL3/A|
|Pump type :||self-priming up to 9m|
|Voltage :||380V< /td>|
|Pump material :||cast iron|
|Impeller material :||brass< /td>|
|Impeller type :||centrifugal|
|Pump location :||horizontal< /td>|
|Type of connection :||thread|
|Spigot diameter :||1x1inch < /td>|
Self-priming monobloc centrifugal pump with built-in ejector.
Using NGL pumps.
NGL pumps manufactured by the company Calpeda (Italy) designed for well water supply,
for lifting water containing air or other gases,
to increase the pressure of water flowing to the pump by gravity when working under hydraulic pressure,
to increase the pressure of water from the distribution network (observe local standards),
for clean water or slightly polluted surface water, in garden areas, for washing with a strong water jet.
NGL pump operating limits.
Liquid temperature from 0 °C to +35 °C.
The ambient air temperature is not more than 40 °C.
Maximum allowable final pressure in the pump housing: 8 bar.
Electric motor for NGL pumps.
Asynchronous 2-pole electric motor, frequency 50 Hz (2800 rpm).
NGL: three-phase 230/400V ±10%, NGLM: single-phase 230V ±10% with thermal protector.
The capacitor is built into the terminal box.
Isolate class "F".
IP 54 Protective Device.
Design according to EN 60335-2-41 (CEI 61-69).
mechanical seal for calpeda NGL3/A pump is in stock
|pump type||самовсасывающий до 9м|
|flow selection m3/h||2|
|selection by head in m||30|
|pump power, kWt||0.55|
Tags: pump calpeda NGL3/A