Pumps with peripheral impeller CT60, CT61

Design

Monoblock pumps with working peripheral wheel.  Compact design, patented, with movable motor housing side cover (replaceable when worn).  The motor is protected from water ingress from outside.  Bronze pumps are supplied fully painted.

Application

for clean, non-explosive liquids that do not contain abrasive and suspended particles and are not aggressive to the materials from which the pump is made.
to increase the pressure supplied from the distribution network (observe local standards).  Due to their small dimensions, these electric pumps are excellently suited for installation in various devices and apparatuses of cooling, air conditioning and circulation systems.  .
 

Operating restrictions

Fluid temperature less than 60°C.
The ambient temperature is less than 40°С.
Manometric suction lift no more than 7 m. 
Continuous operation.

electric motor

Induction motor, 2-pole, 50 Hz, 2900 rpm.
CT 61: three-phase - 230/400 V (±10%)
CTM 61: mono-phase 230 V (±10%) with thermal protection device Capacitor built into the terminal box.
Class "F" insulation.
Protective device IP 54.
Device in accordance with EN 60335-2-41.

Special executions on request

other voltage
frequency 60 Hz (see catalog for frequency 60 Hz)
with protection device IP 55

Component	ST 61	V-ST 61
Pump housing	Cast iron GJL 200 EN 1561	Bronze G-Cu Sn 10 EN 1982
Engine side cover	Brass R-Cu Zn 40 Pb 2 UNI 5705
Working wheel	Brass R-Cu Zn 40 Pb 2 UNI 5705
Shaft	Chrome steel AISI 430
Fur. seal	Charcoal - Ceramics - NBR
Component	ST 60	V-ST 60
Pump housing	Cast iron GJL 200 EN 1561	Bronze G-Cu Sn 10 EN 1982
Engine side cover	Brass R-Cu Zn 40 Pb 2 UNI 5705
Working wheel	Brass R-Cu Zn 40 Pb 2 UNI 5705
Shaft	Chrome steel AISI 430
Fur. seal	Charcoal - Ceramics - NBR

n = 2900 rpm