Pumps with peripheral impeller T,TP

design

Monoblock electric pumps with a working peripheral wheel.  Bronze pumps are supplied fully painted.

Application

for clean, non-explosive liquids, free of abrasive and suspended particles and not aggressive to the materials of which the pump is made
to increase the pressure supplied from the distribution network (observing local standards) due to their small dimensions, these electric pumps are very well suited for installation in various devices. and devices of cooling, air conditioning, circulation and
power supply systems for boilers

Operating restrictions

Fluid temperature from -10 to +90°C.
The ambient temperature is less than 40°С.
Manometric suction lift no more than 7 m.
Continuous operation.

electric motor

Induction motor, 2-pole, 50 Hz, 2900 rpm.  T, TR: three-phase - 230/400 V (±10%), up to 3 kW;
400/690 V±10%, 4 to 7.5 kW.  TM, TRM: monophase 230 V (±10%) with thermal protection device. The capacitor is built into the terminal box.  IEC 60335-1
(EN 60335-1).

Special executions on request

other voltages
frequency 60 Hz (see catalog for frequency 60 Hz)
with protection device IP 55

Component	T, TR	V-T, V-TR
Pump housing Connect part	Cast iron GJL 200 EN 1561	Bronze G-Cu Sn 10 EN 1982
case cover	Cast iron GJL 200 EN 1561	Bronze G-Cu Sn 10 EN 1982
	Brass R-Cu Zn 40 Pb 2 UNI 5705 in mod. T 61-65-70, V-T 61-70
Working wheel	Brass R-Cu Zn 40 Pb 2 UNI 5705 Bronze G-Cu Sn 10 UNI 7013 mod. T 125, TR 132-132R
Shaft	Chrome-nickel steel Cr-Ni AISI 303 T76, Tr 80-100	Chrome nickel molybdenum steel
	Chrome steel AISI 430 T 61-65-70, T100-125, Tr 78-132-132R	AISI 316
Fur. seal	Charcoal - Ceramics - NBR